Archived · Classic Cars · 2 min read
FJ Holden Specifications
Holden FJ Technical Specifications FJ Holden Sedan click here for info... Holden Colour Codes A - L Holden Colour Codes M -Z GM Holden Price Guide…
This date is the archive capture date; the original publication date was unavailable.

Historical article recovered from a Wayback capture dated 2024-12-05.

FJ Holden Sedanclick here for info…
Years of Manufacture: 1953 - 1956
Number Built: 169,969
Price at Introduction: £1023 ($2064)
Models:
- Standard Sedan
- Business Sedan
- Special Sedan
- Panel Van
- Utility
Date(s) of Introduction:
- All Models (except Panel Van) - October, 1953
- Panel Van - December, 1953
To Identify:
- Similar body to 48/215 but with open grille and thick horizontal chrome bar
“Holden” badge mounted on front centre of bonnet
Centrally mounted rear stop light with chrome surround
Body:
- Unitary construction (Monocoque)
Exterior Dimensions:
- Total Length: 173.3 inches (4401mm)
- Total width: 66.9 inches (1702mm)
- Height at kerb weight: 62.3 inches (1581mm)
- Wheelbase: 103.0 inches (2616mm)
- Front Track: 53.0 inches (1346mm)
- Rear Track: 54.0 inches (1372mm)
Also see:
Kerb Weight:
- 2250lb (1012kg)
Turning Circle:
- 37ft (11.3 metres)
Instruments:
- Speedometer
- Petrol gauge
- Heat indicator
- Oil warning lamp
- Generator warning lamp
Transmission:
- 1st: 2.985:1 to top speed of 30 mph (48 km/h)
- 2nd: 1.591:1 to top speed of 52 mph (84 km/h)
- 3rd: 1.00:1 to top speed of 80.4 mph (129 km/h)
- Reverse: 2.985:1
Clutch:
- Single-plate, dry disc, diaphragm type spring driven plate cushioned to hub by four high rate coil springs
Rear Axle Ratio:
- 3.894:1
Engine/Transmission Combinations:
- Standard six-cylinder engine and three speed manual
0-60 mph (0-97 km/h):
- 19.0 seconds
Standing Quarter Mile (400 metres):
- 20.4 seconds
Engine:
- Capacity: 2160cc 132.5 cubic inches (2.171 litres)
- Type: Conventional, watercooled four stroke, reciprocating piston type with 6 cylinders
- Configuration: Front mounted, longitudinal, inline
- Head: Pushrod and rocker actuated ohv with two valves per cylinder
- Fuel System: Stromberg double venturi downdraft type carburettor
- Bore and Stroke: 3.00 x 3.125 inches (76.2 x 79.4mm)
- Power: 60bhp (45kw) at 3800rpm
- Torque: 100lb-ft (135Nm) at 2000rpm
- Compression Ratio: 6.5:1
Ignition and Electrical:
- 6 volt
- Coil and generator
Exhaust:
- Single tail-pipe, straight through resonance type muffler
Suspension:
- Front: Short and long arm independent type with coil springs
- Rear: Hotchkiss Drive with semi-elliptic springs
Steering:
- Worm and sector type, ratio 14:1
Brakes:
- Front: Hydraulic 9 inch (229mm) drums
- Rear: Hydraulic 9 inch (229mm) drums
Wheels:
- Demountable disc wheels with drop centre type rim integral with wheel
Tyres:
- Low pressure balloon 5.50x15 four-ply (Standard), 5.90x15 four-ply (Special)





